生活點滴

Inside and outside calipers use

Inside and outside calipers is the most simple measuring tools. Outside calipers used to measure the outside diameter and flat, calipers are used to measure the diameter and groove. They themselves can not be directly read out the measurements, but measurement of the length of the size (diameter of a length of size), steel ruler, reading, or on a steel ruler to remove the required size, go to the test parts The diameter of compliance.

A caliper to open degrees adjustment

First check the shape of the jaw, jaw shape measurement accuracy, you should pay attention to regular trimming the shape of the jaws, jaw shape of good and bad contrast. Adjust the opening of the caliper, gently tap the calipers on both sides of the foot surface. Caliper adjustment with both hands and the size of the workpiece close to the opening, and then tap the outside of the caliper to reduce the opening of the caliper, tap the calipersbrake racing the inside to increase the opening of the caliper. This is because the caliper jaw injury in the amount of surface caused by measurement error. More knocking on the rail of the machine calipers.

2, the use of outside calipers

Outside calipers on a steel ruler to remove the size of the measurement surface of a clamp foot leaning against the side surface of the steel ruler, and the measurement of another clamp foot face of the quasi-required size in the middle of the groove, and two measuring surface The line should be parallel with the steel ruler, and the people's attention to the vertical steel ruler.

Use has been on a steel ruler to take a good size outside calipers to measure the outside diameter, make two vertical parts of the line for measuring surface axis, over the parts depend on the weight of outside calipers cylindrical, should we feel in the hands of outside calipers and parts of cylindrical exactly is the point contact, outside calipers, two measuring the distance between the surface and is measured zero change than the outer diameter of the tester. So, outside calipers to measure diameter, the degree of tightness of the calipers of the relatively outer part cylindrical contact. When the calipers over the cylindrical our hands no contact feeling on the outside calipers parts outside diameter size, such as relying on the outside calipers weight can not be over the part cylindrical, it shows the outside calipers than a small part outside diameter. Must not be askew calipers placed on the workpiece measurement, such error. Outside caliper calipers have flexibility, puts pressure on the outer circle is wrong, not the caliper sideways card up. For the large size of the outside calipers, relied on weight over the part-cylindrical measurement of pressure is too great, and you should lift up the calipers to measure.

3, within the calipers use

Within the caliper measurement of internal diameter should be two clamp foot measuring surface line exactly perpendicular to the axis of the bore, two measuring surfaces of the clamp feet should be the end points of the bore diameter. Therefore, the measurement should be to stop the measurement surface of the clamp feet below the pore walls as a fulcrum, the clamp feet above entered, some gradually out to test the orifice slightly and swing along the circumferential direction of the hole wall, along the hole wall circumference direction can swing the distance for the most hours, said caliper foot two measuring surface in the inner hole diameter of the two end points. Then the calipers to slowly move from the outside, you can test the roundness tolerance of the hole. Been in a steel ruler or outside calipers to take a good size inside caliper to measure the inside diameter. Is a comparison of calipers in the tightness of the hole parts. Hole has a larger swing freely within the caliper, said caliper size smaller than the aperture; such as within the calipers will not fit into, or into the hole after the tight swing freely, it means that within the caliper size than the aperture big, such as calipers into the hole, in accordance with the above-mentioned measurement method 1 ~ 2MM free-swinging distance, when the aperture with calipers size, just equal. Measurements by hand, do not grasp the caliper measurement, so the feel, difficult to compare the calipers in the tightness of the hole parts, and caliper distortion arising from measurement error.